Knowledge Base Glossary    Contact Us
Search  
   
Browse by Category
Knowledge Base .: Nuvio 2.x .: Embarq 660HW Bridge Modem Instructions

Embarq 660HW Bridge Modem Instructions

Bridging The 660HW Gateway   
  The 660HW Gateway brings back the ability to bridge the gateway. The main reason to do so is to prevent a Double-NAT situation, or to allow a customer to host up to 4 Static IP’s via the gateways 4 physical Ethernet ports.   
  
  1. Login to the modem at 192.168.2.1 using the default password of 1234. Click Ignore when it asks to change your password, and select Advance Setup.
  2. Click on the (+) plus next to Maintenance on the left hand Navigation Menu, and select Diagnostic.
  3. Click CHANGE TO BRIDGE MODE
 Please contact your ISP for more assistance with bridging your modem. These instructions are simple guide lines on how to bridge this modem. We are not liable for any issues with hardward or network configurations.

 


How helpful was this article to you?

Related Articles

article 2Wire Modem Issue Fix
This article explains the configuration changes...

(No rating)  2-19-2009    Views: 2497   
article Router/Modem - Known configuration issues
Below is a list of devices being used on the...

(No rating)  9-24-2008    Views: 5560   
article Nuvio Provisioning Instructions for SPA2102-R
Note: If you have a Linksys SPA-2102,...

(No rating)  6-13-2008    Views: 5115   

User Comments

Add Comment
No comments have been posted.


powered by Lore
Copyright © 2003 - 2009, Nuvio Corporation . All Rights Reserved.